Description

A completely new mineral oil based grease for use in the Alcoa Wheels wheel assembly. The grease helps to prevent corrosion and leaves no marks on the surface of the rims. During operation, dirt and other foreign bodies are accumulated around the wheel rim and the hub surface. In addition, water and road salt may oxidize the center hole of the rim. This causes the rims to attach to the hubs, which significantly hinders disassembly of the wheels. Note: The grease must not be used for mounting or lubricating valves. HUBgrease grease can prevent the following problems and significantly facilitate the maintenance of the wheels.

• Prevents galvanic corrosion around the hub bore
• High temperature resistance (up to 150 ° C)
• Easy to use
• Resistant to oxidation
• Waterproof

Description

Corrosive grease acting as a corrosion inhibitor when mounting or replacing valves. The grease does not damage the rubber seal of the valve and prevents leaks. VALVEgrease is also used in the Alcoa production facility for pre-lubricating valves and valve openings.

• Prevents corrosion in the valve opening area
• Tested on all valves mounted on Alcoa Wheels wheels
• Easy to use
• Waterproof
• Do not use for mounting tires on rims We recommend replacing the valve each time the tire changes. This will prevent the spread of corrosion and leakage around the valve opening.

Description

Stainless steel nut covers for 32 mm hex nuts. Suitable for Alcoa sleeved Dacromet® cap nuts (32 mm bolt hole Ø mounting) and most OE nuts (26 mm bolt hole Ø mounting). Fits: GAX578032 and GAX578132

Description

Stainless steel nut covers for 33 mm hex nuts Suitable for Alcoa sleeved Dacromet® cap nuts (32 mm bolt hole Ø mounting) and most OE nuts (26 mm bolt hole Ø mounting). Fits: GAX578232, GAX578332, GAX578432 and GAX578532

Description

Mounting grip to easily apply and remove nut covers.

Description

Bristle Discs are a key product for the maintenance of Alcoa Wheels wheels and keep them in the best possible condition. shields can be used to clean the seat areas of the tire feet, the surface of the wheel rim, the pins and the centering hubs of the hub. The blades fit most angle grinders and also remove sharp edges that occur when flanges wear rims, corrosion, traces of oxidation and dirt. The removable washer is used to attach the disc. The pad has an internal thread suitable for standard 6.3 mm x 20 spindles. Products are available with soft, medium and hard bristles and in 2 diameters (Ø 25 and Ø 50 mm).

White disc: soft for maintenance of aluminum parts
Yellow shield: medium hard to remove light oxidation
Green disc: hard to remove strong oxidation

Dial with a diameter of 25 mm:

• For cleaning the centering edges of the hubs, pins and inner edges of the center hole of the rim from dirt and rust

• For cleaning larger parts of the rim and hub